WHEEL BEARING HUB UNIT INSTALLING TOOLS SET | FOR VAG | BEARING UNIT Ø 62, 66, 72 MM (6250)

The PRO+ class wheel bearing hub mounting tool kit BGS Technic 6250 is designed for mounting and dismounting GEN2 (second generation) bearings. The kit allows for quick and safe installation of GEN2 bearings directly on the car, without removing chassis components. Specialized tools simplify the removal of deeply embedded bearings, reducing the risk of damaging chassis parts and saving significant labor time.

The tools can be used in a workshop with a press, or directly on the vehicle.

This tool kit is essential when working with GEN2 bearings, as their integrated design means that conventional tools can damage the bearing or surrounding components. The tools are suitable for practically all VAG [Volkswagen Audi Group] vehicles with GEN2 bearings.

Kit contents and technical specifications:

1 x universal pressing bell

3 x pressing plates

3 x control elements

2 x half-shells [black] for 72 mm bearing [VW Polo | Seat Ibiza | VW Fox with PAS | Audi A1 | Audi A2 | Seat Cordoba | Skoda Fabia | Skoda Roomster ]

2 x half-shells [chrome] for 66 mm bearing [VW Fox | VW Polo | Skoda Fabia]

2 x half-shells [anodized] for 62 mm bearing [VW Lupo | Audi A2 ]

2 x mounting bolts for half-shells M12x1.5

2 x mounting bolts for half-shells M14x1.5

1 x spindle with bearing M20

1 x carrying case for tools

total weight [kg]: 13.300
 

Tools suitable for the following VAG models with GEN2 bearings: Audi A1 | Audi A2 | Audi A2 1.2L | VW Lupo | VW Polo | VW Fox | VW Fox with PAS [Power-Assisted Steering] | Seat Ibiza | Seat Cordoba | Skoda Fabia | Skoda Roomster

INSTRUCTIONS FOR USE:

- mount the appropriate half-shells according to the bearing diameter (62, 66, or 72 mm)

- slide the bearing and the appropriate pressing element onto the spindle. The outer diameter of the pressing element must be close to the diameter of the wheel bearing housing

- thread the spindle with the mounted bearing and pressing element through the wheel hub from the rear

- slide the new bearing assembly with the mounted half-shells and pressing bell onto the spindle from the front

- install the bearing and hand-tighten the spindle nut to pre-secure the wheel bearing assembly

- check the correct alignment of the tool parts and adjust them if necessary

- turn the spindle nut clockwise using a ratchet wrench, while holding the spindle with a wrench on the other side

- pull the wheel bearing assembly into the wheel bearing housing until the bearing's locking projections engage in the designated recess

SAFETY INSTRUCTIONS:

- read the instructions carefully before starting work

- use the tool only for its intended purpose

- when lifting the vehicle, use the manufacturer's specified lifting points

- before working under the vehicle, ensure it is properly secured with axle stands or ramps. Block the wheels and check that the handbrake is engaged

- wear gloves and safety glasses during work

- ensure the tool is correctly assembled

- do not overtighten the spindle or apply excessive force, as this may damage the tool or components

- the tool is not suitable for use with impact wrenches. Using an impact wrench can damage the spindle bearing or other parts, and flying fragments can cause injuries

- always refer to the operating instructions for detailed guidance

- lubricate screw threads with grease before using the tool

- check and replace damaged parts if necessary

- keep children away from the work area

- keep these tools out of reach of children.

BGS Technic 6250 User Manual PDF