WHEEL BEARING PRESS SET | VAG | 62 / 66 / 72 MM (6250V)

The PRO class wheel bearing hub installation tool kit 6250V is designed for the installation and removal of GEN2 (second generation) bearings. The kit allows for quick and safe installation of GEN2 bearings directly on the car, without removing chassis parts. Specialized tools simplify the removal of deeply embedded bearings, reducing the risk of damage to chassis parts and saving a lot of working time.

The tools can be used in workshops with a press, or directly on the vehicle.

This tool kit is essential when working with GEN2 bearings, as their integrated design means that conventional tools can damage the bearing or surrounding parts. The tools are suitable for almost all VAG [Volkswagen Audi Group] vehicles with GEN2 bearings.

Kit contents and technical specifications:

1 x universal pressing cap

3 x pressing plates

3 x control elements

2 x half-shells [black] for 72 mm bearing [VW Polo | Seat Ibiza | VW Fox with PAS | Audi A1 | Audi A2 | Seat Cordoba | Skoda Fabia | Skoda Roomster ]

2 x half-shells [chrome-plated] for 66 mm bearing [VW Fox | VW Polo | Skoda Fabia]

2 x half-shells [anodized] for 62 mm bearing [VW Lupo | Audi A2 ]

2 x mounting bolts for half-shells M12x1.5

2 x mounting bolts for half-shells M14x1.5

1 x spindle with bearing M20

1 x tool case

total weight [kg]: 13.300

Tools suitable for these VAG models with GEN2 bearings: Audi A1 | Audi A2 | Audi A2 1.2L | VW Lupo | VW Polo | VW Fox | VW Fox with PAS [Power-Assisted Steering] | Seat Ibiza | Seat Cordoba | Skoda Fabia | Skoda Roomster

USAGE:

- install the appropriate half-shells according to the bearing diameter (62, 66, or 72 mm)

- place the bearing and the appropriate pressing element onto the spindle. The outer diameter of the pressing element should be close to the diameter of the wheel bearing housing

- pass the spindle with the installed bearing and pressing element through the wheel hub from the rear

- place the new bearing assembly with the installed half-shells and pressing cap onto the spindle from the front

- install the bearing and hand-tighten the spindle nut to pre-secure the wheel bearing assembly

- check the proper arrangement of the tool parts and, if necessary, align them

- turn the spindle nut clockwise using a ratchet wrench, and hold the spindle with a wrench on the other side

- draw the wheel bearing assembly into the wheel bearing housing until the bearing's locking protrusions engage in the designated notch

SAFETY INSTRUCTIONS:

- read the instructions carefully before starting work

- use the tool only for its intended purpose

- when lifting the vehicle, use the manufacturer's specified lifting points

- before working under the vehicle, ensure it is properly secured with axle stands or ramps. Block the wheels and check that the handbrake is engaged

- wear gloves and safety glasses during work

- ensure the tool is properly assembled

- do not overtighten the spindle or apply excessive force, as this may damage the tool or components

- the tool is not suitable for use with impact wrenches. Using an impact wrench can damage the spindle bearing or other parts, and flying fragments can cause injuries

- always refer to the work instructions for detailed guidance

- lubricate the screw threads with grease before using the tool

- check and, if necessary, replace damaged parts

- keep children away from the work area

- keep these tools out of reach of children.